1987 Lotus Excel project :D
Moderator: Board Moderators
- MetBlue
- Senior Poster
- Posts: 1445
- Joined: Sat Mar 24, 2018 21:00
- Model: Elite 74 & Excel 92 (SEish))
- Colour: Metalic Blue
- Year: 1974
- Location: Northampton
Re: 1987 Lotus Excel project :D
Great progress. Pleased you can see light at the end of the tunnel ( I won't do the train bit ).
When we going to get chance to see it?
Tony
When we going to get chance to see it?
Tony
What goes together.... Must come apart.
-
- Senior Poster
- Posts: 3733
- Joined: Tue Apr 04, 2006 21:28
- Model: Elite
- Colour: Monaco White
- Year: 1974
- Location: Nottingham
Re: 1987 Lotus Excel project :D
Pretty sure it's on the handbrake mounting bracket.
Pete
Pete
-
- Senior Poster
- Posts: 286
- Joined: Tue May 09, 2017 17:47
- Model: Excel SE (Now gone)
- Colour: White
- Year: 1988
- Location: Northamptonshire
Re: 1987 Lotus Excel project :D
It is, Peter. 4 screws to remove the tunnel-mounted cubby. If my memory serves me correctly, it's then 2 screws to release the back of the tunnel trim and you can then pull the tunnel top trim back to disengage it at the front and lift the rear high enough to see the switch. Unscrew the gearknob and slide the trim off the gear stick and handbrake to remove it completely for better access.
What car is that?
- DavidOliver
- Senior Poster
- Posts: 694
- Joined: Fri Nov 07, 2014 11:18
- Model: Excel
- Colour: Calypso Red
- Year: 1985
- Location: Malaga Spain
Re: 1987 Lotus Excel project :D
The switch is under the hanbrake handle. You need to remove the leather trim which is one screw and peel upwards.
Quite often the trim gets in the way of the switch, so with the trim off try the switch light.
Dave the cog.
Quite often the trim gets in the way of the switch, so with the trim off try the switch light.
Dave the cog.
-
OnlineExcel SA
- Senior Poster
- Posts: 515
- Joined: Thu Jul 02, 2020 06:11
- Model: Excel
- Colour: White
- Year: 1987
- Location: Johannesburg, South Africa
Re: 1987 Lotus Excel project :D
The light is also connected to the brake fluid reservoir - so if the fluid is low, or that switch is faulty, that could also be the cause.
Neil.
Neil.
Re: 1987 Lotus Excel project :D
Thank you very much everyone i will check all that at the weekend when i get a chance. It has been on since i got the car home which from memory it did have a good amount of fluid.
Nick
Nick
I haven't seen daylight in 17 years now i have been finally rescued
Re: 1987 Lotus Excel project :D
Hey Guys,
Well i have pulled up the centre console of the lotus and there is a switch under the handbrake that which when the handbrake is down it hits the switch so i take it that is the one. So what i did was disconnected the switch and connected a wire between the connectors to see if the light goes out and it didn't so it doesnt seem to be the switch i am now scratching my head to figure out what the issue is with keeping the handbrake light on.
I hope this makes since.
Well i have pulled up the centre console of the lotus and there is a switch under the handbrake that which when the handbrake is down it hits the switch so i take it that is the one. So what i did was disconnected the switch and connected a wire between the connectors to see if the light goes out and it didn't so it doesnt seem to be the switch i am now scratching my head to figure out what the issue is with keeping the handbrake light on.
I hope this makes since.
I haven't seen daylight in 17 years now i have been finally rescued
-
- Senior Poster
- Posts: 3733
- Joined: Tue Apr 04, 2006 21:28
- Model: Elite
- Colour: Monaco White
- Year: 1974
- Location: Nottingham
Re: 1987 Lotus Excel project :D
If you look at the wiring diagram you'll see that the same circuit is activated by the brake fluid level sensor as well - check that part of the circuit next.
Pete
Pete
Re: 1987 Lotus Excel project :D
Thanks Pete,Pete Boole wrote: ↑Sat Sep 04, 2021 11:18If you look at the wiring diagram you'll see that the same circuit is activated by the brake fluid level sensor as well - check that part of the circuit next.
Pete
However, i dont have a wiring diagram lol
I haven't seen daylight in 17 years now i have been finally rescued
-
- Verified Poster
- Posts: 16
- Joined: Sun May 23, 2021 13:11
- Model: SE
- Colour: White
- Year: 1986
- Location: Shropshire
Re: 1987 Lotus Excel project :D
Hi,
I'm not familiar with Lotus's yet, just moving over from Triumphs.
But the way a brake light switch normally operates is, the contacts make to bring the handbrake light on. So a check would be similar to what you did, but take the connectors off the switch, don't connect them, just leave them. If the lights go out, the switch is faulty.
Dave
I'm not familiar with Lotus's yet, just moving over from Triumphs.
But the way a brake light switch normally operates is, the contacts make to bring the handbrake light on. So a check would be similar to what you did, but take the connectors off the switch, don't connect them, just leave them. If the lights go out, the switch is faulty.
Dave
Re: 1987 Lotus Excel project :D
Hello guys and Girls .
Ok She is ready to go off to a friend to have the last bits fixed on the car she has new boots that have been powder coated and i am very happy how they turned out. However, She is having a running issue where if you gently push on the throttle she will rev up as normal but if you push it hard when she is cold or hot she really struggles then revs like she is starving of fuel or air please see video below.
https://youtu.be/jA4us8GoOHI
https://youtu.be/-3xoN7W2Z8c
If you can please help with ideas why she is running like this that would be a big help when i hand her over.
I am missing some pipes of the below which i believe is for the cold start. Does anyone know what size the pipes are please.
Isn't she pretty
Ok She is ready to go off to a friend to have the last bits fixed on the car she has new boots that have been powder coated and i am very happy how they turned out. However, She is having a running issue where if you gently push on the throttle she will rev up as normal but if you push it hard when she is cold or hot she really struggles then revs like she is starving of fuel or air please see video below.
https://youtu.be/jA4us8GoOHI
https://youtu.be/-3xoN7W2Z8c
If you can please help with ideas why she is running like this that would be a big help when i hand her over.
I am missing some pipes of the below which i believe is for the cold start. Does anyone know what size the pipes are please.
Isn't she pretty
I haven't seen daylight in 17 years now i have been finally rescued
- Hawaiis0
- Senior Poster
- Posts: 4166
- Joined: Sun Jun 30, 2013 18:39
- Model: Excel SA (No 3); Elite 504
- Colour: BRG; Dirty White
- Year: 1986
- Location: West Oxfordshire
Re: 1987 Lotus Excel project :D
Nick that is the purge pump for hot start assistance, it purges the inlet airbox. Hose is about half inch.
Nothing is fool proof. Fools are clever!
Re: 1987 Lotus Excel project :D
Thanks stu sorry what I meant was the diameter of the hose to pop on the pump.
I haven't seen daylight in 17 years now i have been finally rescued
Re: 1987 Lotus Excel project :D
I haven't seen daylight in 17 years now i have been finally rescued
- MetBlue
- Senior Poster
- Posts: 1445
- Joined: Sat Mar 24, 2018 21:00
- Model: Elite 74 & Excel 92 (SEish))
- Colour: Metalic Blue
- Year: 1974
- Location: Northampton
Re: 1987 Lotus Excel project :D
Great work.
Feel like we should arrange a Sunday coffee / breakfast meet for North Oxford / South Northants so we can take a proper ganda. - Any interest?
Time to enjoy (and drive).
Tony
Feel like we should arrange a Sunday coffee / breakfast meet for North Oxford / South Northants so we can take a proper ganda. - Any interest?
Time to enjoy (and drive).
Tony
What goes together.... Must come apart.