The driver's side carpet was torn up and partially missing and the passenger side was filthy and not looking like much would remain after it had been scrubbed so that all had to come out, the headlining had been ripped out and replaced badly by a previous owner with creme vinyl which had lots of air bubbles and lumpy glue. So I have replaced the carpets and started on the headlining.
This is just as I was clearing the lumps of glue from the roof.
I hooked an oversized section of headlining in the gap at the rear of the roof and used bits of cardboard to wedge it in
Then sprayed High Temp glue on the underside of the roof and upper face of the headlining material.
and then cut the excess off with a Stanley knife OK the edges are a bit rough, but the trim panels go over that area...
and then put the rear seats back in, I know the bit over the roll over bar will have to come back out when I do the front section next weekend but it's safe from dirt where it is!
and some pics of the rest.. Eventually I might get the leather clean!