Thanks ,again to Mike Taylor.

General Excel discussions. You may also post Eclat and Elite information here. If there is enough call I will set up new categories or even a new BB for them.

Moderator: Board Moderators

Post Reply
terry
Senior Poster
Posts: 318
Joined: Thu Nov 03, 2005 12:43

Thanks ,again to Mike Taylor.

Post by terry »

Just as a Thank you to Mike at Lotusbits, and a tip to you guys, in case you come up against the same problem!

Replaced the whole of my braking system, calipers. discs,pads,master cylinder, servo.

This was a while ago, now it's all up and running again, I couldn't get it past the MOT because the pads were not backing off the discs, so they were binding.

I WAS going to take all the calipers apart, work the pistins back and forward, regrease the sliders, but fortunately phoned Mike first.

What he said made a lot of sense, jack wheel up, push the pedal down, cannot turn wheel.

break open the bleed valve on the caliper, if the wheel free's up, it's the fluid pressure, not dropping.

His next bit of advice was that it would be the pushrod between the MC and the servo.

took it off, screwed it in 4mm, worked, got MOT.
I just assembled it assuming the pushrod length would be right!!!!


Thanks Mike.

User avatar
Ozzy_UK
Senior Poster
Posts: 1431
Joined: Fri Jan 06, 2006 11:12
Year: 0
Location: Guildford, Surrey
Contact:

Re: Thanks ,again to Mike Taylor.

Post by Ozzy_UK »

what mike doesnt know about excels isnt worth knowing...
he is always my first point of call...

brilliant service, and very friendly.

i look forward to spending more money on your 6 pot brake system soon mike!
V8 donor car has been bought and is going to the workshop tomorrow!!
full rebuild of the car will be started soon!
Oz.
Oran Maliphant
---------------------------------------
Mercedes B250e “Tesla” 2015
MGF 1.8i Steptronic CVT 2001
Honda Civic Type R EP3 2004
Volvo V70 T5 2002
Lotus Excel 4.0l V8 1987 #2470

Post Reply