Davies Craig EWP80 conversion

Post discussions on potential upgrades and modifications here, as well as documenting successfully implemented projects.

Moderator: Board Moderators

Post Reply
User avatar
Lotus-e-Clan
Senior Poster
Posts: 4454
Joined: Thu Nov 30, 2006 13:25
Model: Excel SE - EWP/Waterless!
Colour: Not Blue or Green
Year: 1989
Location: Swaledale

Davies Craig EWP80 conversion

Post by Lotus-e-Clan »

Here's an outline representation of the write-up I did on my EWP80 conversion many years ago. The original has disappeared from the forum. I didn't replace it so far as it's a pain to do, and the forum may be liable to futurer losses -who knows?

My original write-up included details of the impellor deletion from the std OE water pump. If you remove the impellor, you need to block the bypass hole between cavities within the casting to keep the circulation routes isolated. Once the impellor is removed, you also need to bung, or aluminium weld, the resultant hole in the casing. I used a simple rubber bung with a through-bolt to compress-fit the bung within the nose of the water pump housing. This rubber bung set-up has lasted since 2004/5, with only occasional tightening of the through bolt required.

NB. I've chopped a Word document / PowerPoint conversion into jpegs so it's easy to post on here without formatting nightmares. I hope it's all clear enough to be useful. :(

Image

Image

Image

Image

Image

Image

Image

Image
Peter K

Post Reply